1、先清除go缓存,用下面命令
go clean -cache
go clean -modcache
2、更新库文件
go mod tidy
3、安装beego
go install github.com/beego/bee/v2@latest
4、查看bee版本
5、进行打包然后传到Centos和麒麟服务器如下代码
bee pack -be GOOS=linux -be GOARCH=amd64 //AMD64架构,一般Centos系统
bee pack -be GOOS=linux -be GOARCH=arm64 //ARM64架构,一般麒麟系统
6、最后写在后面,后台运行 go 及服务器关闭Selinx和防火墙
后台运行如下命令: nohup ./go &
关闭直接杀死Pid就可以了,如下图:ps aux | grep go
防火墙管理如下:
- 关闭防火墙,使用命令 systemctl stop firewalld
- 永久关闭, 执行命令 systemctl disable firewalld
- 关闭SELinux 临时关闭:运行命令 setenforce 0
- 永久关闭,打开/etc/selinux/config文件,将SELINUX=enforcing改为SELINUX=disabled
- 如果非要打防火墙及SElinux,则需要把对应的端口开放,比如开放80,8080,8081等
sudo firewall-cmd --permanent --add-port=8081/tcp
sudo firewall-cmd --permanent --add-service=http
sudo firewall-cmd --permanent --add-service=https
# 重新加载防火墙
sudo firewall-cmd --reload